Verilink Net Engine (3150-30626-001) Product Manual - Manual (Page 89)

NetEngine IAD User Guide
WAN Configuration 70
Setting the
Interface to
T1 or E1
To determine the WAN interface setting, or to switch the WAN interface for
use in a T1 (North American) or E1 environment, type
5 (Configure WAN)
on the Main menu to display the WAN Configuration menu for T1/E.
Figure 4–21. WAN Configuration Menu for T1/E1
1. Type 2 to select Configure Physical Interface.
2. The IAD displays the T1 ( Figure 4–22 ) or E1 Configuration menu
( Figure 4–23 ), depending on how your IAD is configured:
Figure 4–22. T1 Configuration Menu
Figure 4–23. E1 Configuration Menu
LAN LINK LAN ACT WAN LINK VOICE POWER
6200-8
7216 This section is for configuring the IAD to use the T1 or E1
WAN interface on the 6200-8 or 7216 IAD.
*****************************************
WAN Configuration Menu
*****************************************
Configuring T1/E1
1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure PVCs
4. Configure ATM Options
*******************************************
T1 Configuration Menu
*******************************************
1. Select Frame Mode (D4 or ESF)
2. Select Transmit Line Build Out
4. Select B8ZS or AMI
5. Configure Loopback
6. Configure Transmit Channels
7. Configure Receive Channels
8. Configure Transmit Clock Source
9. Change to E1 Mode
*******************************************
E1 Configuration Menu
*******************************************
1. Select Frame/CRC4 Mode
4. Configure S-Bits
5. Configure Transmit Channels
6. Configure Receive Channels
7. Configure Clock Source
8. Change to T1 Mode
P. Display Physical Layer Stats and Alarm Log