Amer Networks SS2R48G4i V2 - Manual (Page 114)

SS2R24G4i/SS2R48G4i
103
{group <g_limit> | source <s_limit>}
No ip igmp snooping vlan < vlan-id >
limit
snooping can join and the max number of
sources each group can have.” No ip igmp
snooping vlan < vlan-id > limit ” will reset it
to default value.
Ip igmp snooping vlan <vlan-id>
l2-general-querier
No ip igmp snooping vlan <vlan-id>
l2-general-querier
Set this vlan to a layer 2 general queirer. It
is recommended that each segment should
configure a layer 2 general queirer.” No ip
igmp snooping vlan <vlan-id>
l2-general-querier” command will cancel
the configuration of layer 2 general queirer
Ip igmp snooping vlan <vlan-id>
mrouter-port interface <interface
–name>
No ip igmp snooping vlan <vlan-id>
mrouter-port interface <interface
–name>
Set the static mrouter por.” No ip igmp
snooping vlan <vlan-id> mrouter-port
interface <interface –name>”command will
cancel the configuration of mrouter port.
Ip igmp snooping vlan <vlan-id> mrpt <
value >
No ip igmp snooping vlan <vlan-id> mrpt
Set the keep-alive time of the mrouter port,
the” No ip igmp snooping vlan <vlan-id>
mrpt” command will reset it to default value
Ip igmp snooping vlan <vlan-id>
query-interval <value>
No ip igmp snooping vlan <vlan-id>
query-interval
Set the query interval, “No ip igmp snooping
vlan <vlan-id> query-interval ” command
will reset it to default value.
Ip igmp snooping vlan <vlan-id>
immediate-leave
No ip igmp snooping vlan <vlan-id>
immediate-leave
Set the IGMP snooping of specified vlan to
enable the immediate-leave function;” No ip
igmp snooping vlan <vlan-id>
immediate-leave”command will cancel
immediate-leave configuraiton.
Ip igmp snooping vlan <vlan-id>
query-mrsp <value>
No ip igmp snooping vlan <vlan-id>
query-mrsp
Set the max query response time,” No ip
igmp snooping vlan <vlan-id> query-mrsp”
command command will reset it to default
value.
Ip igmp snooping vlan <vlan-id>
query-robustness <value>
No ip igmp snooping vlan <vlan-id>
query-robustness
Set the robustness, “No ip igmp snooping
vlan <vlan-id> query-robustness” will reset
it to default value.
Ip igmp snooping vlan <vlan-id>
suppression-query-time <value>
No ip igmp snooping vlan <vlan-id>
suppression-query-time
Set the suppression time of query; “No ip
igmp snooping vlan <vlan-id>
suppression-query-time” will reset it to
default value.
ip igmp snooping vlan <vlan-id>
tatic-group <multicast-IPAddress>
interface {[ethernet|port-channel]
<interfaceName>
No ip igmp snooping vlan <vlan-id>
Set the statci group of the specified port,
the “No ip igmp snooping vlan <vlan-id>
tatic-group <multicast-IPAddress> interface
{[ethernet|port-channel] <interfaceName>
command will cancel the configuration.