Amer Networks SS2R48G4i V2 - Manual (Page 131)

SS2R24G4i/SS2R48G4i
120
dot1x max-user userbased <number>
no dot1x max-user userbased
Set the max number of the users allowed
to access by specified port, applied to
ports using userbased access control
mode; the “ no dot1x max-user
userbased ” command is used to reset
the default value allowing 10 users at
most.
3) Configure expanded 802.1x function
Command Explanation
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
Enables the 802.1x address filter
function in the switch; the "no dot1x
macfilter enable" command disables
the 802.1x address filter function.
dot1x accept-mac <mac-address>
[interface <interface-name>]
no dot1x accept-mac <mac-address>
[interface <interface-name>]
Adds 802.1x address filter table entry,
the “no dot1x accept-mac” command
deletes 802.1x filter address table
entries.
dot1x eapor enable
no dot1x eapor enable
Enables the EAP relay authentication
function in the switch; the “no dot1x
eapor enable” command sets EAP local
end authentication.
dot1x unicast enable
no dot1x unicast enable Enable the 802.1x single-cast
authentication function of the switch;
the “no dot1x unicast enable”
command is used to diable the802.1x
single-cast authentication function.
dot1x BPDU_forward enable
no dot1x BPDU_forward enable Enable the 802.1x traversal function of
the switch; the “no dot1x
BPDU_forward enable ” command is
used to diable the 802.1x traversal
function of the switch.
dot1x freevlan <vlanID>
no dot1x freevlan Set the 802.1x freevlan of the switch;
the” no dot1x freevlan” command is
used to disable the 802.1x freevlan
function.
3. Supplicant related property configuration
Command Explanation
Global Mode