Amer Networks SS2R48G4i V2 - Manual (Page 189)

SS2R24G4i/SS2R48G4i
178
police aggregate
<aggregate-policer-name>
no police aggregate
<aggregate-policer-name>
Apply a policy set to classified traffic;
the “no police aggregate
<aggregate-policer-name>
”
command deletes the specified policy
set.
4．Apply QoS to ports
Command Explanation
Interface Mode
mls qos trust [cos | dscp | port priority
<priority>]
no mls qos trust
Configure port trust; the “no
mls qos trust
” command
disables the current trust
status of the port.
mls qos cos {<default-cos> }
no mls qos cos
Configure the default CoS
value of the port; the “no
mls qos cos
” command
restores the default setting.
service-policy {input <policy-map-name> | output
<policy-map-name>}
no service-policy {input <policy-map-name> |
output <policy-map-name>}
Apply a policy map to the
specified port; the “no
service-policy {input
<policy-map-name> |
output
<policy-map-name>} ”
command deletes the
specified policy map applied
to the port. Egress policy
map is not supported yet.
mls qos dscp-mutation
no mls qos dscp-mutation
Apply DSCP mutation
mapping to the port; the “no
mls qos dscp-mutation
command restores the
DSCP mutation mapping
default.
5. Configure queue out method and weight
Command Explanation
Interface Mode
wrr-queue bandwidth <weight1 weight2
weight3 weight4>
no wrr-queue bandwidth
Set the WRR weight for specified egress
queue; the “no wrr-queue bandwidth”
command restores the default setting.
priority-queue out
no priority-queue out
Configure queue out method to pq
method; the “no priority-queue out”
command restores the default WRR
queue out method.
wrr-queue cos-map <queue-id> <cos1 ... Set CoS value mapping to specified