Amer Networks SS2R48G4i V2 - Manual (Page 82)

SS2R24G4i/SS2R48G4i
71
Chapter 7 Port Configuration
7.1 Port Introduction
Fig 7-1 Ports on SS2R24G4i
The ports on SS2R24G4i switch are showed in the above picture. SS2R24G4i provides 24＋2＋2
ports, 24 of wich are 10/100Base-TX ethernet interfaces with fixed configuration, 2 of which are
1000Base-TX/1000Base-FX single/multi mode interfaces, the other 2 of which are 1000Base-TX stack
interfaces.
On the panel of SS2R24G4I, each port is marked with a port ID. The relationshipbetween these
port IDs and the port IDs provided by the SS2R24G4I operating system (software port IDs)is listed as
follows
Physical port ID Software port ID
24 10/100Base-T ethernet 0/0/1-24
2 1000Base-TX/1000Base-FX ethernet 0/0/25-26
2 1000Base-TX ethernet 0/0/27-28
If users want to configure some ports, they can use the command interface ethernet <interface-list>
to enter corresponding ethernet port configuration mode, the parameter <interface-list> can be
0/0/1-28. When <interface-list> contains more than one ports, please use special charactuer
including”;”and “-” to connect them. In the ethernet port configuration mode, the port rate, duplex mode
and the traffic control can all be configured, in response, the performace of corresponding ports will
change accordingly.
7.2 Port Configuration
7.2.1 Port Configuration
7.2.1.1 Port Configuration Task List
1. Enter the network port configuration mode
2. Configure the properties for the network ports
1) Configure combo mode for combo ports
2) Enable/Disable ports
3) Configure port names