Amer Networks SS2R48G4i V2 - Manual (Page 162)

SS2R24G4i/SS2R48G4i
151
17.3 Port Channel Example
Scenario 1 Configuring Port Channel in LACP.
S1
S2
Fig 17-2 Configuring Port Channel in LACP
Example The switches in the description below are all SS2R24/48G4i switch switch and as shown in
the figure, ports 1, 2, 3 of Switch1 are access ports that belong to vlan1. Add those three ports to
group1 in active mode. Ports 6, 7, 8 of Switch2 are trunk ports that also belong to vlan1,and allow all.
Add these three ports to group2 in passive mode. All the ports should be connected with cables
The configuration steps are listed below
Switch1#config
Switch1 (Config)#interface eth 0/0/1-3
Switch1 (Config-Port-Range)#port-group 1 mode active
Switch1 (Config-Port-Range)#exit
Switch1 (Config)#interface port-channel 1
Switch1 (Config-If-Port-Channel1)#
Switch2#config
Switch2 (Config)#port-group 2
Switch2 (Config)#interface eth 0/0/6
Switch2 (Config-Ethernet0/0/6)#port-group 2 mode passive
Switch2 (Config-Ethernet0/0/6)#exit
Switch2 (Config)# interface eth 0/0/8-9
Switch2 (Config-Port-Range)#port-group 2 mode passive
Switch2 (Config-Port-Range)#exit
Switch2 (Config)#interface port-channel 2
Switch2 (Config-If-Port-Channel2)#
Configuration result
Shell prompts ports aggregated successfully after a while, now ports 1, 2, 3of Switch 1 form an
aggregated port named “Port-Channel1”, ports 6, 7, 8 of Switch 2 forms an aggregated port named
“Port-Channel2”; configurations can be made in their respective aggregated port configuration mode.