Amer Networks SS2R48G4i V2 - Manual (Page 80)

SS2R24G4i/SS2R48G4i
69
1) Enable or disable joining the cluster automatically
2) Set holdtime of heartbeat of the cluster
3) Set interval of sending heartbeat packets among the switches of the cluster
4) Clear the list of candidate switches discovered by the commander switch
4. Configure attributes of the cluster in the candidate switch
1) Set interval of sending cluster register packet
5. Remote cluster network management
1) Remote configuration management
2) Reboot member switch
3) Remotely upgrade member switch
1.Enable or disable cluster
Command Explanation
Global Mode
cluster run
no cluster run
Enable or disable cluster function
in the switch
2．Create a cluster
Command Explanation
Global Mode
cluster commander <cluster-name>
[vlan<vlan-id>]
no cluster commander
Create or delete a cluster
cluster ip-pool<commander-ip>
no cluster ip-pool
Configure private IP address pool
for member switches of the cluster
cluster member {candidate-sn <cand-sn> |
mac-address <mac-add>
[<mem-id>] }[password <pass>]
no cluster member < mem-id >
Add or remove a member switch
3． Configure attributes of the cluster in the commander switch
4. Configure attributes of the cluster in the candidate switch
Command Explanation
Command Explanation
Global Mode
cluster auto-add enable
no cluster auto-add enable
Enable or disable adding newly discovered
candidate switch to the cluster
cluster holdtime < second>
no cluster holdtime
Set holdtime of heartbeat of the cluster
cluster heartbeat <interval>
no cluster heartbeat
Set interval of sending heartbeat packets
among the switches of the cluster
clear cluster candidate-table
Clear the list of candidate switches
discovered by the commander switch