Amer Networks SS2R48G4i V2 - Manual (Page 161)

SS2R24G4i/SS2R48G4i
150
z All Ports are of the same type
z All ports are Access ports and belong to the same VLAN or are all Trunk ports.
z If the ports are Trunk ports, then their “Allowed VLAN” and “Native VLAN” property should also be
the same.
If Port Channel is configured manually or dynamically on SS2R24/48G4i switch switch, the system
will automatically set the port with the smallest number to be Master Port of the Port Channel. If the
spanning tree function is enabled in the switch, the spanning tree protocol will regard Port Channel as a
logical port and send BPDU frames via the master port.
Port aggregation is closely related with switch hardware. SS2R24/48G4i switch switch allow physical
port aggregation of any two switches, maximum 8 port groups and 8 ports in each port group are
supported.
Once ports are aggregated, they can be used as a normal port. SS2R24/48G4i switch switch have
a built-in aggregation interface configuration mode, the user can perform related configuration in this
mode just like in the VLAN and physical port configuration mode.
17.2 Port Channel Configuration
17.2.1 Port Channel Debug and Monitor Command
1． Create a port group in Global Mode.
2． Add ports to the specified group from the Port Mode of respective ports.
3． Enter port-channel configuration mode.
1. Creating a port group
2. Add
physical
ports to the
port group
3. Enter
port-channel
configuration
mode.
Command Explanation
Global Mode
interface port-channel <port-channel-number>
Enters port-channel
configuration mode.
Command Explanation
Global Mode
port-group <port-group-number>
[load-balance { dst-src-mac }]
no port-group <port-group-number>
[ load-balance]
Creates or deletes a port group and
sets the load balance method for that
group.
Command Explanation
Interface Mode
port-group <port-group-number> mode {active|passive|on}
no port-group <port-group-number>
Adds ports to the
port group and
sets their mode.