Amer Networks SS2R48G4i V2 - Manual (Page 133)

SS2R24G4i/SS2R48G4i
122
radius-server accounting host
<IPaddress> [[port {<portNum>}]
[primary]]
no radius-server accounting host
<IPaddress>
Specifies the IP address or IPv6 address
and listening port number for RADIUS
accounting server; the “no radius-server
authentication host
<IPaddress>“ command deletes the
RADIUS server
3) Configure RADIUS Service parameters.
Command Explanation
Global Mode
radius-server dead-time <minutes>
no radius-server dead-time
Configures the restore time when
RADIUS server is down; the “no
radius-server dead-time” command
restores the default setting.
radius-server retransmit <retries>
no radius-server retransmit
Configures the re-transmission times for
RADIUS; the “no radius-server
retransmit” command restores the
default setting
radius-server timeout <seconds>
no radius-server timeout
Configures the timeout timer for RADIUS
server; the “no radius-server timeout”
command restores the default setting.
radius-server realtime-accounting
timer <minute>
Set the realtime cost-counting update
interval.
14.3 Example of 802.1x Application
10.1.1.1
10.1.1.2
Radius Server
10.1.1.3
Fig 14-2 IEEE802.1x Configure Topology of the example