Amer Networks SS2R48G4i V2 - Manual (Page 36)

SS2R24G4i/SS2R48G4i
25
Fig 4-7 Telnet Configuration Interface
4.1.2.2 Management via HTTP
To manage the switch via HTTP, the following conditions should be meet
1) Switch has an IP address configured;
2) The host IP address and the switch’s VLAN interface IP address is in the same network
segment.
3) If not 2), Telnet client can connect to an IP address of the switch via other devices, such as a
router.
Similar to management via Telnet, as soon as the host succeeds to ping an IP address of the
switch and to type the right login password, it can access the switch via HTTP. The configuration list is
as below
Step 1 Configure the IP addresses for the switch and start the HTTP function on the switch.
For configuring the IP address on the switch through out-of-band management, see the relevant
chapter.
To enable the WEB configuration, users should type the CLI command ip http server in the global
mode as below
Switch >en
Switch#config
Switch(Config)#ip http server
Step 2 Run HTTP protocol on the host.
Open the Web browser on the host and type the IP address of the switch.Or run directly the HTTP
protocol on the Windows. For example, the IP address of the switch is “10.1.128.251”.