Amer Networks SS2R48G4i V2 - Manual (Page 126)

SS2R24G4i/SS2R48G4i
115
Server 210.1.1.1 is sending important multicast data in the group 239.1.2.3 上, we can configure as
follows on its access switch
Switch(Config)#ip multicast policy 210.1.1.1 0.0.0.0 239.1.2.3 0.0.0.0 cos 4
Thus when the multicast strem is passing the TRUNK of this switch to other switches, it will be at
priority 4(usually it is a high priority, the higher might be protocol data, but if we set higher priority, when
there is too much multicast data, may cause abnormal behavior of the switch protocol)
13.4 DCSCM Troubleshooting
13.4.1 DCSCM Debug and Monitor Command
13.4.1.1 show ip multicast source-control access-list
Command show ip multicast source-control access-list
show ip multicast source-control access-list <5000-5099>
Function To display the configured source control multicast ACL.
Parameters <5000-5099> ACL ID
Default Settings None.
Command Mode Admin Mode
13.4.1.2 show ip multicast destination-control access-list
Command show ip multicast destination-control access-list
show ip multicast destination-control access-list <6000-7999>
Function To display the configured destination control multicast ACL,
Parameters <6000-7999> ACL ID.
Default Settings None.
Command Mode Admin Mode
13.4.1.3 show ip multicast policy
Command show ip multicast policy
Function To display the configured multicast policy.
Parameters None.
Default Settings None.
Command Mode Admin Mode
13.4.1.4 show ip multicast source-control
Command show ip multicast source-control [detail]
show ip multicast source-control interface <Interfacename> [detail]
Function To display the multicst control configuration.