Amer Networks SS2R48G4i V2 - Manual (Page 56)

SS2R24G4i/SS2R48G4i
45
Command show flash
Function Display the document in the flash
Command Mode Admin Mode
5.2.5.5 show history
Command show history
Function Display the recent user input history command
Command Mode Admin Mode
5.2.5.6 show memory
Command show memory
Function Display the contents in the memory
Command Mode Admin Mode
5.2.5.7 show rom
Command show rom
Function Display enable document and bulk
Command Mode Admin Mode
5.2.5.8 show running-config
Command show running-config
Function Display the current active configuration parameters for the switch.
Default If the active configuration parameters are the same as the default operating parameters,
nothing will be displayed.
Command mode Admin Mode
5.2.5.9 show startup-config
Command show startup-config
Function Display the switch parameter configurations written into the Flash memory at the current
operation; those are usually also the configuration files used for the next power-up.
Default If the configuration parameters read from the Flash are the same as the default operating
parameter, nothing will be displayed.
Command mode Admin Mode
5.2.5.10 show switchport interface
Command show switchport interface [ethernet <interface-list>]
Function Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port
mode on the switch.
Parameter <interface-list> is the port number or port list, which could be maximum of 0/0/1 port in