Amer Networks SS2R48G4i V2 - Manual (Page 197)

SS2R24G4i/SS2R48G4i
186
will delete the default gateway address.
23.2 ARP
23.2.1 Introduction to ARP
ARP (Address Resolution Protocol) is mainly used in IP address to Ethernet MAC address resolution.
SS2R24/48G4i switch supports static configuration.
23.2.1.1 ARP Configuration Task Sequence
1. Configure static ARP
Command Explanation
arp <ip_address> <mac_address>
no arp <ip_address>
Configure a static ARP entry; the “no arp
<ip_address>”
command deletes a static
ARP entry.
23.2.2 ARP Forwarding Troubleshooting
23.2.2.1 Monitor and Debug Commands
23.2.2.1.1 show arp
Comman show arp [<ip-addr>][<vlan-id>][<hw-addr>][type {static|dynamic}][count]
Function Display the ARP table.
Parameter <ip-addr> is a specified IP address; <vlan-id> stands for the entry for the identifier of
specified VLAN; <hw-addr> for entry of specified MAC address; “static” for static ARP entry;
“dynamic” for dynamic ARP entry; “count” displays number of ARP entries.
Command mode Admin Mode
Command Explanation
Addrss
IP address of Arp entries 2.2.2.66
Hardware Address MAC address of Arp entries
00-10-00-00-00-C5
Interface Layer3 interface corresponding to the ARP