Yaskawa DriveWizard AC Drive - Manual (Page 101)

4. Click on the Monitors Tab ( ). All of the parameters selected in step 3 should be
displayed. If they are not, go back to the Setup Tab and make sure there are checks in the
boxes next to the parameters to be observed. The value column will be blank when the
monitor is turned off.
Figure 6.3: Monitor Window with Monitor Stopped
5. Click on the Start command under the Monitor Menu (or from the Tool Bar) to start
monitoring the selected parameters. DriveWizard
™ will start continuously monitoring these
parameters for changes in these values, and their values will be displayed under the Monitors
Tab. Note that the red heart in the lower right hand side of the status bar is flashing,
indicating that DriveWizard
™ is monitoring the drive.
Figure 6.4: Monitor Active – Heartbeat Icon
Using the Monitor
Monitor Active
orrectly during monitor operation.
Note!
On the GPD315/V7, n152 (Memobus Ref Units) must be set to 1 for the
scaling of Frequency Ref (U-01) and Output Frequency (U-02) to read
c
101