Yaskawa DriveWizard AC Drive - Manual (Page 93)

Cell Attributes
Other useful parameter information is indicated in the parameter editor as well and are listed and
described below.
• Green Bullet
Appears in the left most column of the parameter editor when the setting has been
adjusted in that session. This status serves as a reminder as to what has been changed. It will
easily identify all the parameters adjusted since connecting to the drive or since opening an
existing parameter file. The user can modify any incorrect adjustments.
The green bullet will only disappear if the Parameter Editor Spreadsheet is
saved to a file or another data set is loaded into the spreadsheet.
• Red Bullet
Appears in the left most column of the parameter editor when DriveWizard
™ has
adjusted the setting in that session. This happens when a master parameter (Table 5.9) that
other parameters are dependent on are changed. The software changes the values as the drive
would if the master parameter had been changed by the drive keypad. An example would be
changing the control mode in G5 (parameter A1-02).
The red bullet will change to a green bullet if the working value of the
parameter is changed by the user after the software has changed that value.
The bullet will disappear if:
• All parameters are uploaded from the drive
• All parameters downloaded to the drive
• Parameters are saved to a file.
For V7 only, the red bullets disappear when the master parameter is
downloaded to the drive.
Param Description Applicable Drive Param
Note!
Note!
Parameter Editor Spreadsheet
Description Applicable
Drive
A1-02 Control Mode G5, F7, G7 n001 Initialize Mode V7
C1-10 Accel / Decel Units G5, F7, G7 n002 Control Mode V7
C6-01 Normal / Heavy Duty F7 n018 Accel / Decel Units V7
E1-03 V/F Pattern G5, E7, F7, G7, P7 n035 Display Mode V7
o1-03 Display Units G5, E7, F7, G7, P7 KVA Setting V7, J7
o2-04 KVA Setting G5, E7, F7, G7, P7 n01 Initialize Mode J7
o2-09 Initial Setting G5, E7, F7, G7, P7
Table 5.9: Master Parameters
93