Yaskawa DriveWizard AC Drive - Manual (Page 60)

Communications Menu
To test the PC to drive Ethernet connection and verify the CMO9x card is operating
properly, a direct connection method can be utilized to check operation. Below are two
examples of connecting the PC directly to the drive equipped with a CMO9x card (Figures 4.33a
and 4.33b):
Figure 4.33a: Direct Ethernet connection of PC to drive via cross-over cable.
Figure 4.33b: Direct Ethernet connection of PC to drive via hub.
The dir
made by either Figure 4.33a with a cross –
over cable
To make a
1. Physic in Figure 4.32.
2. Co
the foll
a. on Start>Settings>Control Panel>Network or Dial up
on
c. ,
e. w
window labeled ”subnet mask
ect connection from the PC to the drive can be
or Figure 4.33b with standard cables and an Ethernet hub.
direct Ethernet connection from the PC to the drive, please follow this procedure:
ally connect the drive to the PC by either of the two methods show
nfigure the PC’s Ethernet adapter IP protocol settings to match the CMO9x card by
owing (if you are permitted to do so):
On you PC click
Connections.
b. Select the Ethernet adapter you have connected the Ethernet cable to and click
that connection to open it’s configuration dialog box (Fig. 4.34a).
In the window titled “ components checked that are used by this connection”
scroll down to the item labeled” Internet Protocol (TCP/IP)” and click on that
item to select it.
d. Click on the properties button and the window in Figure 4.34b will appear.
Select the item ”use the following IP address:” and fill in the address windo
with 192.168.1.1 as shown in Figure 4.34c. The
will fill in automatically with the numbers as shown when the IP address is
entered. Leave the “Default gateway”, “Preferred DNS server”, and “Alternate
DNS server” windows blank.
60