Hitachi X200 Series User Manual
Page 136
Miscellaneous Functions
The following table contains miscellaneous functions not in other function groups.
“C” Function
Defaults
Func.
Code
Name /
SRW Display
Description
Run
Mode
Edit
-FE
(EU)
-FU
(USA) Units
Debug mode enable *
C091
DBG Slct
OFF
Displays debug parameters.
Two option codes:
00
…Disable
01
…Enable <Do not set>
(for factory use)
9
00
00
−
Up/Down memory mode
selection
C101
UP/DWN
NO-STR
Controls speed setpoint for the
inverter after power sycle.
Two option codes:
00
…Clear last frequency (return to
default frequency F001)
01
…Keep last frequency adjusted
by UP/DWN
U
00
00
−
Reset selection
C102
RS Slct
ON
Determines response to Reset
input [RS].
Three option codes:
00
…Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01
…Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
02
…Cancel trip state at input ON
transition, no effect if in Run
Mode
U
00
00
−
CAUTION: Do not change Debug mode for safety reasons. Otherwise unexpected
performances may occur.
3−62
Config
uri
ng Driv
e
Parameters