Allied Telesis AT-S63 - Manual (Page 108)

Chapter 7: Static Port Trunks
108 Section I: Basic Operations
3. Select the Port Trunking tab.
The Port Trunking tab is shown in Figure 29 on page 105.
4. Click the button next to the port trunk you want to modify and click
Modify.
The Modify Trunk page is shown in Figure 31.
Figure 31. Modify Trunk Page
Note
You cannot change the Trunk ID number or the load distribution
method of a static port trunk from the web browser interface.
5. Configure the following parameter as necessary.
Trunk Name
The name can be up to 16 alphanumeric characters. No spaces or
special characters, such as asterisks and exclamation points, are
allowed. Each trunk must have a unique name.
6. To add or remove ports from a trunk, click the ports in the graphical
image of the switch. A selected port changes to white. An unselected
port is black. A static port trunk can contain up to eight ports.
7. Click Apply. Changes to a port trunk are activated on the switch.
8. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
9. Reconnect the cables to the ports of the trunk.