Configuring authenticator port parameters – Allied Telesis AT-S63 User Manual
Page 401
AT-S63 Management Software Web Browser Interface User’s Guide
Section VI: Port Security
401
Configuring Authenticator Port Parameters
To configure authenticator port parameters, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Network Security option.
The Network Security page opens with the Port Security tab selected
by default, as shown in Figure 158 on page 392.
3. Select the 802.1x Port Access tab. The 802.1x Port Access tab is
shown in Figure 162 on page 398.
4. Click the authenticator port that you want to configure. You can select
more that one authenticator port at a time. The selected port turns
white.
Note
The role of a port must be set to authenticator before you can
configure the authenticator port settings. For instructions on how to
set a port’s role, refer to “Setting Port Roles” on page 398.
5. Click Settings.