Allied Telesis AT-S63 - Manual (Page 208)

Chapter 15: Quality of Service
208 Section II: Advanced Operations
None - Disables this function.
All - All packets are remarked.
DSCP Value
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
Traffic Class List
Specifies the traffic classes to be assigned to the policy. The traffic
classes must already exist. Select the classes from the list. To select
more than one, use <Ctrl> click.
Ingress Port List
Specifies the ingress ports to which the policy is to be assigned. Select
the ports from the list. To select more than one, use <Ctrl> click. A port
can be an ingress port of only one policy at a time.
Egress Port
Specifies the egress port to which the policy is to be assigned. A port
can be an egress port of only one policy at a time.
Redirect Port
Specifies the port to which the classified traffic from the ingress ports is
redirected.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a
Policy
To modify a policy, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the Policies tab.
The Policies tab is shown in Figure 75 on page 206.
4. Select a policy from the list and click Modify.