Allied Telesis AT-S63 - Manual (Page 242)

Chapter 18: SNMPv3
242 Section III: SNMPv3
Note
You may want to assign NONE to a super user.
6. In the Authentication Password field, enter an authentication password
of up to 32 alphanumeric characters.
7. In the Confirm Authentication Password field, re-enter the
authentication password.
Note
If you have the nonencrypted version of the AT-S60 software, then
the Privacy Protocol field is read-only.
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
8. In the Privacy Protocol field, enter one of the following options:
DES
Select this value to make the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are encrypted
with the DES protocol.
None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
9. In the Privacy Password field, enter a privacy password of up to 32
alphanumeric characters.
10. In the Confirm Privacy Password field, re-enter the privacy password.
11. In the Storage Type field, enter one of the following storage options for
this User Table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 User Table. After making changes to an SNMPv3 User
Table entry with a Volatile storage type, the Save Config option is not
displayed on the Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 User Table. After making changes to an SNMPv3 User Table