Allied Telesis AT-S63 - Manual (Page 420)

Chapter 26: Encryption Keys, PKI, and SSL
420 Section VII: Management Security
Displaying the PKI Settings and Certificates
You can view the current PKI settings and certificates on the switch. To
configure the PKI settings and certificates, you must use the AT-S63
menus or command line interface. For more information about PKI, refer
to the AT-S63 Management Software Menus Interface User’s Guide.
To display the PKI settings and certificates, perform the following
procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Mgmt. Security option.
The Mgmt. Security page is displayed with the Mgmt. ACL tab
displayed by default, as shown in Figure 184 on page 449.
3. Select the PKI tab.
The PKI tab is shown in Figure 172.
Figure 172. PKI Tab (Monitoring)
The upper section states the maximum number of certificates that can
be configured on the switch.
The lower section displays a table that lists the currently configured
certificates and contains the following columns of information: