Modifying a port mirror – Allied Telesis AT-S63 User Manual
Page 117
AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Features
117
Modifying a Port Mirror
To modify a port mirror, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 1 option.
The Layer 1 page opens with the Port Settings tab displayed by
default, as shown in Figure 20 on page 78.
3. Select the Port Mirroring tab.
The Port Mirroring tab is shown in Figure 33 on page 114.
4. Click Modify.
The Modify Mirror page is shown in Figure 34 on page 115.
5. Click the ports of the port mirror to change its type. Clicking a port
toggles it through the possible settings, which are as follows:
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
The destination (mirror) port. There can be only one
destination port.
A source port. The port’s ingress traffic is mirrored to the
destination port.
A source port. The port’s egress traffic is mirrored to the
destination port.
A source port. The port’s ingress and egress traffic is
mirrored to the destination port.
Not part of a port mirror.