Allied Telesis AT-S63 - Manual (Page 168)

Chapter 12: Classifiers
168 Section II: Advanced Operations
Deleting a Classifier
To delete a classifier, perform the following procedure:
Note
You cannot delete a classifier if it belongs to an ACL or QoS policy.
You must first remove it from the ACL or policy before you can
delete it.
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
Note
You can access the Classifiers tab either through the Network
Security menu option or through the Services menu option. This
procedure uses the path through the Network Security menu option.
2. From the Configuration menu, select the Network Security option.
The Network Security page is displayed with the Port Security tab
selected by default, as shown in Figure 158 on page 392.
3. Select the Classifier tab.
The Classifier tab is shown in Figure 48 on page 161.
4. Click the button next to the classifier you want to delete and click
Delete.
The classifier is deleted from the switch.
5. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)