Allied Telesis AT-S63 - Manual (Page 127)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 127
The FIle System tab for an AT-9400 Series switch with a flash memory
card drive is shown in Figure 37.
Figure 37. File System Tab (Configuration)
The information in the tab is defined below:
Current Drives
Specifies the location of the file system. An AT-9400 Series switch that
does not feature a flash card slot has just one selection, Flash, which
represents the flash memory in the switch. An AT-9400 Series switch
that has a flash card slot has two selections, Flash and Flash Card.
The example tab in Figure 37 is from a switch that has a flash card
slot.
Default Configuration File
Specifies the filename of the active configuration file. The switch uses
this file to configure its operating parameters when it is reset or power
cycled. The active boot file is also the file that is updated when you
select the Save Config option.
The columns in the List Files table are described below. This
information is for viewing purposes only. If your unit has a compact
flash card slot, the switch, by default, displays the files in flash
memory. To view the files on a card, go to step 4.
File Name
Name of the system file.