Allied Telesis AT-S63 - Manual (Page 346)

Chapter 21: Port-based and Tagged VLANs
346 Secton V: Virtual LANs
Creating a New Port-Based or Tagged VLAN
To create a new port-based or tagged VLAN, perform the following
procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 123 on page 302.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 143.
Figure 143. VLAN Tab (Configuration)
Note
The Modify and Remove buttons are not shown in the tab if the only
VLAN on the switch is the Default_VLAN.