Chapter 20, Multiple spanning tree protocol, Chapter 20: multiple spanning tree protocol – Allied Telesis AT-S63 User Manual
Page 319
Section IV: Spanning Tree Protocols
319
Chapter 20
Multiple Spanning Tree Protocol
This chapter explains how to configure multiple spanning tree protocol
(MSTP) parameters on an AT-9400 Series switch using a web browser
management session. It contains the following procedures:
“Configuring MSTP” on page 322
“Creating, Deleting, or Modifying MSTI IDs” on page 326
“Adding, Removing, or Modifying VLAN Associations to MSTIs” on
page 330
“Configuring MSTP Port Parameters” on page 333
“Displaying the MSTP Port Configuration” on page 337
“Displaying the MSTP Port Status” on page 340
“Displaying the MSTP Port Status” on page 340
“Resetting MSTP to the Default Settings” on page 342
Note
For background information on MSTP, refer to Chapter 24, “Multiple
Spanning Tree Protocol,” in the AT-S63 Management Software
Menus Interface User’s Guide.