Allied Telesis AT-S63 - Manual (Page 356)

Chapter 21: Port-based and Tagged VLANs
356 Secton V: Virtual LANs
Multiple - The non-IEEE 802.1Q-compliant multiple VLAN mode.
Management VLAN ID
VLAN ID of the management VLAN.
The lower part of the tab displays a table that contains the following
columns of information:
VLAN ID
The VID number assigned to the VLAN.
(Client) Name
The name of the VLAN. If the switch is operating in one of the multiple
VLAN modes, the names of the VLANs start with “Client,” with the
exception of the VLAN containing the uplink port, which starts with
“Uplink.”
Uplink Port
This column contains “NA,” meaning Not Applicable, for tagged and
port-based VLANs. For a protected ports VLAN, this column contains
the uplink port(s) for the port groups. A tagged uplink port is
designated with a “T” and an untagged uplink port has a “U.” If the
switch is operating in one of the two multiple VLAN modes this column
displays the port that is functioning as the uplink port for the other ports
on the switch.
VLAN Type
The VLAN type. The possible settings are:
Port Based - The VLAN is a port-based or tagged VLAN.
GARP - The VLAN was automatically created by GARP.
Protocol
The protocol associated with this VLAN. The possible settings are:
Blank - The VLAN is a port-based or tagged VLAN.
GARP - The VLAN is a dynamic GVRP VLAN or the port is a dynamic
GVRP port of a static VLAN.
Tagged(T)/Untagged(U) Port
Lists the ports of the VLAN. Tagged ports are designated with a “T”
and untagged ports with a “U.”