Allied Telesis AT-S63 - Manual (Page 22)

Preface
22
New Features in AT-S63 Version 1.2.0
Table 1 lists the new features in version 1.2.0 of the AT-S63 management
software and includes pages references to the relevant procedures. (Only
one of the new features in version 1.2.0, the Supplicant Mode parameter
for 802.1x authenticator ports, is supported in the web browser interface.)
Table 1. New Features in AT-S63 Version 1.2.0
Change Chapter and Procedure
MAC Address Table
Added new parameters to the CLI
commands for deleting and displaying
specific types of MAC addresses in the
MAC address table. The new
parameters are:
ˆ STATIC, STATICUNICAST, and,
STATICMULTICAST for displaying
and deleting static unicast and
multicast MAC addresses.
ˆ DYNAMIC, DYNAMICUNICAST,
and, DYNAMICMULTICAST for
displaying and deleting dynamic
unicast and multicast MAC
addresses.
The web interface supports displaying MAC
addresses, as explained in Chapter 6, “MAC Address
Table” on page 93, but not the new parameters. The
new parameters are only supported in the CLI
interface.
Quality of Service - Flow Groups and Traffic Classes
Added the following new parameters to
QoS flow groups and traffic classes:
ˆ ToS parameter for replacing the
Type of Service field of IPv4
packets.
ˆ Move ToS to Priority parameter for
replacing the value in the 802.1p
priority field with the value in the
ToS priority field on IPv4 packets.
ˆ Move Priority to ToS parameter for
replacing the value in the ToS
priority field with the 802.1p priority
field on IPv4 packets.
The web browser interface supports the management
of flow groups and traffic classes, as explained in
Chapter 15, “Quality of Service” on page 191, but not
the new parameters. The new parameters are
supported in the menus and command line interfaces.