Displaying the port status, Figure 166: 802.1x port access tab (monitoring) – Allied Telesis AT-S63 User Manual
Page 407
AT-S63 Management Software Web Browser Interface User’s Guide
Section VI: Port Security
407
Displaying the Port-based Network Access Control Parameters
You can display information about the port-based network access control
status and settings of the ports on the switch. This section contains the
following procedures:
”Displaying the Port Status” (next)
“Displaying the Port Settings” on page 408
Displaying the
Port Status
To display the port-based network access control port status, perform the
following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select Network Security.
The Network Security page is displayed with the Port Security tab
selected by default, as shown in Figure 160 on page 395.
3. Select the 802.1x Port Access tab. The 802.1x Port Access tab is
shown in Figure 166.
Figure 166. 802.1x Port Access Tab (Monitoring)