Allied Telesis AT-S63 - Manual (Page 311)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols 311
State
Current state of the port. The possible states are Enabled or Disabled.
Cost
Port cost of the port. The default is Auto-Update.
Priority
The number used as a tie-breaker when two or more ports have equal
costs to the root bridge.
6. Click OK to close the page.
Resetting STP to
the Default
Settings
To reset STP to the factory default settings, perform the following
procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab shown by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 124 on page 303.
4. Click Configure.
The Configure STP Parameters tab is shown in Figure 125 on page
305.
5. Click Defaults.
The STP settings are returned to their default values.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)