Allied Telesis AT-S63 - Manual (Page 131)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 131
3. Select the File System tab.
The File System tab for an AT-9400 series switch with a compact flash
card is shown in Figure 37 on page 127.
4. In the Default Configuration File field, enter the name of the file. When
entering the file name, not the following:
ˆ Be sure to include the “.cfg” extension.
ˆ If the file is stored on a flash card in the switch, precede the name
with “cflash:”.
5. Click Apply.
The switch searches the file system or flash memory card for the file. If
it finds the file, it displays the file name in the Default Configuration File
field along with the word “Exists.” The file is now the active boot
configuration file for the switch.
If the switch can not locate the file, it again displays the name of the
previous boot configuration file. Repeat steps 4 and 5, being sure to
enter the name correctly.
6. Do one of the following:
ˆ To configure the switch using the parameter settings in this boot
configuration file, do not select Save Config. Instead, reset or
power cycle the switch.
ˆ To overwrite the settings in the configuration file with the switch’s
current operating settings, select Save Config.