Figure 124: spanning tree tab (configuration) – Allied Telesis AT-S63 User Manual
Page 303
AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols
303
The Spanning Tree tab is shown in Figure 124.
Figure 124. Spanning Tree Tab (Configuration)
4. To enable or disable spanning tree, click the Enable Spanning Tree
check box. A check indicates that the feature is enabled while no
check indicates that the feature is disabled. The default is disabled.
5. To select a spanning tree version, for the Active Protocol Version
parameter click STP, RSTP, or MSTP. The default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
8. If you activated STP, go to “Configuring STP” on page 304. If you
activated RSTP go to Step “Configuring RSTP” on page 312. If you
activated MSTP, go to Chapter 20, ”Multiple Spanning Tree Protocol”
on page 319.