Allied Telesis AT-S63 - Manual (Page 247)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 247
NonVolatile
Select this storage type if you want the ability to save an entry in the
View Table. After making changes to a View Table entry with a
NonVolatile storage type, the Save Config option is displayed on the
Configuration menu. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 View Table entry
takes effect immediately.
10. Click Apply to update the SNMPv3 View Table.
11. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a View
Table Entry
To delete an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure.
The SNMPv3 View Table tab is shown in Figure 93 on page 245.
4. Click the button next to the View Table entry that you want to delete
and then click Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying a View
Table Entry
To modify an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.