Allied Telesis AT-S63 - Manual (Page 385)

AT-S63 Management Software Web Browser Interface User’s Guide
Section V: Virtual LANs 385
Deleting a Protected Ports VLAN
To delete a protected ports VLAN from the switch, perform the following
procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 123 on page 302.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 143 on page 346.
4. Click the button next to the name of the protected ports VLAN you
want to delete. You cannot delete the Default_VLAN.
5. Click Remove.
A confirmation prompt is displayed.
6. Click OK to delete the VLAN or Cancel to cancel the procedure.
If you click OK, the VLAN is deleted from the switch. All ports in the
VLAN are returned to the Default_VLAN as untagged ports.
7. To permanently save the change, select the Save Config menu
selection.