Allied Telesis AT-S63 - Manual (Page 268)

Chapter 18: SNMPv3
268 Section III: SNMPv3
Configuring the SNMPv3 Target Address Table
You can create, delete, and modify an SNMPv3 Target Address Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 268
ˆ “Deleting a Target Address Table Entry” on page 271
ˆ “Modifying Target Address Table Entry” on page 272
For reference information about the SNMPv3 Target Address Table, see
Chapter 22, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a Target
Address Table
Entry
To create an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table, and then click Configure at the bottom of the tab.