Allied Telesis AT-S63 - Manual (Page 154)

Chapter 11: Event Logs and Syslog Servers
154 Section II: Advanced Operations
Facility Level
The numerical code to be added to the entries sent to the syslog
server to group the entries according to the module or switch that
produced them.
The facility levels are described in Table 3.
Note
For further information about the syslog facility levels, refer to
Chapter 13, “Event Logs and Syslog Servers” in the AT-S63
Management Software Menus Interface User’s Guide.
Module Selections
Specifies the AT-S63 management software module(s) whose events
you want to send to the syslog server. To select more than one, use
<Ctrl>+click. For a list of modules, refer to Table 1 on page 147.
5. Click Apply.
The switch creates the new log output server definition and
immediately begins sending events to the server if you enabled the
Message Generation option.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Viewing a Log
Output Definition
To view an existing log output definition, perform the following procedure:
1. From the home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 42.
2. Select the Event Log tab.
The Event Log tab is shown in Figure 41 on page 145.
3. In the Configured Log Outputs section, select a log output from the list
and click View.
Table 3. Default Syslog Facilities
Facility Mapped Event Log Modules and Events
Default This facility number applies the functional
groupings defined in the RFC 3164 standard.
local 1 through
local 7 An identifier to assign to specific switches or
groups of switches.