Allied Telesis AT-S63 - Manual (Page 438)

Chapter 28: TACACS+ and RADIUS Protocols
438 Section VII: Management Security
Configuring RADIUS
To configure RADIUS, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 177 on page
432.
3. In lower section of the Server-based Authentication tab, click RADIUS
Configuration and click Configure.
The RADIUS Client Configuration page is shown in Figure 178.
Figure 181. RADIUS Client Configuration Page
4. Configure the following parameters as necessary.
Global Encryption Key
If all of the TACACS+ servers have the same encryption secret, you
can enter the key here. If the servers have different keys, you must
specify each key when you specify a server’s IP address.
Global Server Timeout
This parameter specifies the maximum amount of time the switch waits
for a response from a TACACS+ server before assuming the server