Allied Telesis AT-S63 - Manual (Page 254)

Chapter 18: SNMPv3
254 Section III: SNMPv3
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 96 on page 250.
4. Click Next or Previous to display the Access Table entry that you
want to delete.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access Table
entry.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 96 on page 250.
4. Click Next or Previous to display the Access Table entry that you
want to change.
5. Click Modify.
The Modify SNMPv3 Access page is shown in Figure 98.