Allied Telesis AT-S63 - Manual (Page 263)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 263
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
ˆ “Creating a Notify Table Entry” on page 263
ˆ “Deleting a Notify Table Entry” on page 265
ˆ “Modifying a Notify Table Entry” on page 266
For reference information about the SNMPv3 Notify Table, see Chapter
22, “SNMPv3” in the AT-S63 Management Software Menus Interface
User’s Guide.
Creating a Notify
Table Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Notify
Table, and then click Configure at the bottom of the tab.