Allied Telesis AT-S63 - Manual (Page 210)

Chapter 15: Quality of Service
210 Section II: Advanced Operations
Egress Port
Specifies the egress port to which the policy is to be assigned. A port
can be an egress port of only one policy at a time.
Redirect Port
Specifies the port to which the classified traffic from the ingress ports is
redirected.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Policy
To delete a policy, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the Policies tab.
The Policies tab is shown in Figure 75 on page 206.
4. Do one of the following:
ˆ Select a policy from the list and click Delete.
ˆ Click Purge to delete all the policies
Displaying
Policies
To display the policies, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select Services.
The Services menu is displayed with the CoS tab selected by default,
as shown in Figure 62 on page 188.
3. Select the Policies tab.