Allied Telesis AT-S63 - Manual (Page 95)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Operations 95
3. To add a static unicast address, in the View/Add Unicast MAC
Addresses section, click Add. To add a static multicast address, in the
View/Add Multicast MAC Addresses section, click Add.
The Add MAC Address page is shown in Figure 26.
Figure 26. Add MAC Address Page
4. Configure the following parameters as necessary.
MAC Address
The new static unicast or multicast MAC address.
Port Number
The number of the port on the switch where you want to assign the
static address. If you are adding a static unicast address, you can
enter only one port.
If you are entering a static multicast address, you must specify the port
when the multicast application is located as well as the ports where the
host nodes are connected. Assigning the address only to the port
where the multicast application is located results in the failure of the
multicast packets to be properly forwarded to the host nodes. You can
specify the ports individually (e.g., 1,4,5), as a range (e.g., 11-14) or
both (e.g., 15-17,22,24).
VLAN ID
The VLAN ID where the port is a member.
5. Click Apply.
6. Repeat this procedure to add other static addresses to the switch.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)