Allied Telesis AT-S63 - Manual (Page 273)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 273
7. In the UDP Port Number field, enter a UDP port number.
You can enter a UDP port in the range of 0 to 65,535. The default UDP
port is 162.
8. In the Timeout field, enter a timeout value in milliseconds.
When an Inform message is generated, it requires a response from the
switch. The timeout value determines how long the switch considers
the Inform message an active message. This parameter applies to
Inform messages only. The range is from 0 to 2,147,483,647
milliseconds. The default value is 1500 milliseconds.
9. In the Retries field, enter the number of times the switch retries, or
resends, an Inform message.
When an Inform message is generated, it requires a response from the
switch. This parameter determines how many times the switch resends
an Inform message. The Retries parameter applies to Inform
messages only. The range is 0 to 255 retries. The default is 3 retries.
10. In the Tag List field, enter a list of tags that you configured with the
Notify Tag parameter in a Notify Table entry.
See “Creating a Notify Table Entry” on page 263. Enter a Tag List of up
to 256-alphanumeric characters. Use a space to separate entries, for
example:
hwengtag swengtag testengtag
11. In the Target Parameters field, enter a Target Parameters name.
This name can consist of up to 32 alphanumeric characters. The value
configured here must match the value configured with the Target
Parameters Name parameter in the Target Parameters Table.
12. In the Storage Type field, enter one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the Target Address Table. After making changes to a Target Address
Table entry with a Volatile storage type, the Save Config option is not
displayed on the Configuration menu.
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Address Table. After making changes to an Target Address
Table entry with a NonVolatile storage type, the Save Config option is
displayed on the Configuration menu. Allied Telesyn recommends this
storage type.