Allied Telesis AT-S63 - Manual (Page 202)

Chapter 15: Quality of Service
202 Section II: Advanced Operations
Max Bandwidth
Specifies the maximum bandwidth available for the traffic class. The
range is 0 to 1016 Mbps. If you set this parameter to 0 (zero), all traffic
that matches that traffic class is dropped.
Priority
Specifies the priority value in the IEEE 802.1p tag control field that
traffic belonging to this traffic class is assigned. The range is 0 to 7
with 0 (zero) as the lowest priority.
Flow Group List
The flow groups assigned to this traffic class. Use <Ctrl> click to select
more than one.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Traffic
Class
To delete a traffic class, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Services option.
The Services page is displayed with the CoS tab selected by default,
as shown in Figure 59 on page 182.
3. Select the Traffic Class tab.
The Traffic Class tab is shown in Figure 70 on page 198
4. Select the traffic class you want to delete and click Delete.
The traffic class is deleted from the list.
Displaying the
Traffic Classes
To display the traffic classes, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select Services.
The Services menu is displayed with the CoS tab selected by default,
as shown in Figure 62 on page 188.