Allied Telesis AT-S63 - Manual (Page 448)

Chapter 29: Management Access Control List
448 Section VII: Management Security
Deleting an ACE
To delete an ACE from the management ACL, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Mgmt. Security option.
The Mgmt. Security page is displayed with the Mgmt. ACL tab selected
by default, as shown in Figure 183 on page 444.
3. Select the ACE you want to delete from the table in the middle section
of the tab and click Delete.
The ACE is deleted from the list. To see the new list, click Refresh.
4. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)