Allied Telesis AT-S63 - Manual (Page 175)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 175
Modifying an Access Control List
To modify an access control list, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by default,
as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Network Security option.
The Network Security page is displayed with the Port Security tab
selected by default, as shown in Figure 158 on page 392.
3. Select the ACL tab.
The ACL tab is shown in Figure 54 on page 172.
4. Select the ACL you want to modify and click Modify.
The Modify ACLs page is displayed, as shown in Figure 56.
Figure 56. Modify ACLs Page
5. Configure the following parameters as necessary:
ID
The ID number of the ACL. You cannot change this value.
Classifier List
Use this list to select the classifier you want to assign to this ACL. You
can assign more than one classifier to an ACL. To select multiple
classifiers, hold down the Ctrl key while making your selections. To
view the classifiers, refer to “Displaying the Classifiers” on page 169.
An ACL must have at least one classifier.