Allied Telesis AT-S63 - Manual (Page 271)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 271
NonVolatile
Select this storage type if you want the ability to save an entry in the
Target Address Table. After making changes to a Target Address Table
entry with a NonVolatile storage type, the Save Config option is
displayed on the Configuration menu. Allied Telesyn recommends this
storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Target Address
Table entry takes effect immediately.
13. Click Apply to update the SNMPv3 Target Address Table.
14. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting a Target
Address Table
Entry
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Address Table tab is shown in Figure 105 on page
269.
4. Click Next or Previous to display the SNMPv3 Target Address Table
entry that you want to delete.
5. Click Remove.
A warning message is displayed.
6. Click OK.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)