Allied Telesis AT-S63 - Manual (Page 434)

Chapter 28: TACACS+ and RADIUS Protocols
434 Section VII: Management Security
Configuring TACACS+
To configure TACACS+, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 177 on page
432.
3. In lower section of the Server-based Authentication tab, click
TACACS+ Configuration and click Configure.
The TACACS+ Client Configuration page is shown in Figure 178.
Figure 178. TACACS+ Client Configuration Page
4. Configure the following parameters as necessary.
Global Secret
If all of the TACACS+ servers have the same encryption secret, you
can enter the key here. If the servers have different keys, you must
specify each key when you specify a server’s IP address.
Global Server Timeout
This parameter specifies the maximum amount of time the switch waits
for a response from a TACACS+ server before assuming the server