Allied Telesis AT-S63 - Manual (Page 166)

Chapter 12: Classifiers
166 Section II: Advanced Operations
Modifying a Classifier
This procedure explains how to modify a classifier. If the classifier you
want to modify is currently assigned to an active ACL or QoS policy, you
must first remove the port assignments from the ACL or policy before you
can modify the classifier. Once you have finished modifying the classifier,
you can reassign the ports again to the ACL or QoS policy.
To modify a classifier, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
Note
You can access the Classifiers tab either through the Network
Security menu option or through the Services menu option. This
procedure uses the path through the Network Security menu option.
2. From the Configuration menu, select the Network Security option.
The Network Security page is displayed with the Port Security tab
selected by default, as shown in Figure 158 on page 392.
3. Select the Classifier tab.
The Classifier tab is shown in Figure 48 on page 161.
4. Click Modify.
The Modify Classifier page is shown in Figure 51.
Figure 51. Modify Classifier Page