Allied Telesis AT-S63 - Manual (Page 72)

Chapter 4: SNMPv1 and SNMPv2c
72 Section I: Basic Operations
Deleting an SNMPv1 and SNMPv2c Community
To delete an existing SNMPv1 and SNMPv2c community, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Mgmt. Protocols option.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 177 on
page 432.
3. Select the SNMP tab.
The SNMP tab is shown in Figure 14 on page 64.
4. In the SNMPv1 & SNMPv2c section, click Configure.
The SNMPv1 & SNMPv2c Communities tab is shown in Figure 15 on
page 66.
5. Click the button next to the community name to delete and click
Remove.
A warning message is displayed.
6. Click OK.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)